2004 haas renishaw probing and tool touch off

[Rcrozb]

Just added a haas mill with probing and tool touch off. The newer haas have a page for probing and touch offs. This one doesn't. Any feed back or things to try? Is there M codes for each part probe? The tool setter is wired in so I figure get it close M code and tool number and subprogram?

 

[GiroDyno]

We have the probing menu in three different places on our 4 VF# mills...

Its normally under MDI, PROG, SETUP

IIRC on one of our weird ones you have to hit Handle Jog mode button x2, see if that brings it up...

 

[Booze Daily]

On my '05..

CURNT COMDS > EDIT > PROG (push 3 times)

This takes you to VQC screen.

Press F2 to get template program list.

Highlight O9996 and press WRITE.

All the calibration routines and pre-made probing cycles are here.

 

[Rcrozb]

On my '05..

CURNT COMDS > EDIT > PROG (push 3 times)

This takes you to VQC screen.

Press F2 to get template program list.

Highlight O9996 and press WRITE.

All the calibration routines and pre-made probing cycles are here.

There isn't a prog. Button on there.

On my '05..

CURNT COMDS > EDIT > PROG (push 3 times)

This takes you to VQC screen.

Press F2 to get template program list.

Highlight O9996 and press WRITE.

All the calibration routines and pre-made probing cycles are here.