What's new
What's new

2006 mits fa10s odd threading issue

plastikdreams

Diamond
Joined
May 31, 2011
Location
upstate nj
So just recently...like yesterday, our fa10s will not return the pipe to the up position after threading. It will go back up on a failed threading event though.

So far my only workaround is to hit stop and then start.

Anyone have any ideas on this?
 

Artefx

Plastic
Joined
Oct 9, 2019
I've believe I've had this issue before.

It was a broken or loose wire / connection on the wire sensor on the rear cutting head. From what I remember there was a wire with an eyelet that had simply undone itself over time.
 

plastikdreams

Diamond
Joined
May 31, 2011
Location
upstate nj
I've believe I've had this issue before.

It was a broken or loose wire / connection on the wire sensor on the rear cutting head. From what I remember there was a wire with an eyelet that had simply undone itself over time.

Ok thanks, ill take a look!
 








 
Top