I am in need of setting up an RPC for my Hardinge.
The lathe name tag shows 4.4amp 1hp.
Also has a 1/6hp coolant pump motor
I am looking at a 5hp American Rotare phase converter.
I have a Doerr Electirc 5hp motor that should serve as the idler.
It is Delta wound (9 wires) so I should be good to go ???
The lathe name tag shows 4.4amp 1hp.
Also has a 1/6hp coolant pump motor
I am looking at a 5hp American Rotare phase converter.
I have a Doerr Electirc 5hp motor that should serve as the idler.
It is Delta wound (9 wires) so I should be good to go ???