What's new
What's new

6f powerfeed motor sealant

KevH

Plastic
Joined
Oct 28, 2018
Stripped down the 6f powerfeed motor and controls to get it working after long storage- controlbox and motor all a bit oily but cleaned up and got working again - I think it had previous work on it and not sealed properly - - Im going to use paper gaskets for the pot cover and front cover - what sealant is recommended for sealing motor to gearhousing?
 
I use Moto Seal from O'reilley Auto. It's solvent based, works well on that motor. Will work on fuel tanks when properly applied and let dry. Permatex #2 is another good choice, non-drying. That's my boss's fav, use it at work all the time.
 








 
Back
Top