What's new
What's new

Activate and deactivate auger during a program in an okuma while running a program?

updatedsecurity

Aluminum
Joined
Jun 6, 2021
Hello.
I was wondering if you could tell me how I could activate the auger in my mill during a program run it for a few minutes and then turn it off without coding it every time and using an m codes. The machine is a Genos 560v the controller is the osp 300.

Thank you
 
Depending on how it's hooked up and what year your control is this can be done with the custom PLC and spare M-codes.
Otherwise you need "dumber" solutions like a timer relay.
 








 
Back
Top