any options for Y ballscrew on TM1

[laurencen]

hi, my Y axis ballscrew is starting to sound a bit rough, took the covers off and figured it was the front bearing but its not, is there any other options for these ballscrews ready to go other than Hass, they seem way overpriced here in Canada

thanks in advance

 

[EMTech]

You can check to see if there are any ballscrew repair places near you. They can regrind the screw and put oversized balls in the bearing.

It can be cheaper to get ballscrews repaired vs buying new, but I have found with the smaller ballscrews like you are talking about, it isn't much cheaper.