smartcolombyan
Plastic
- Joined
- Dec 24, 2020
Anyone have a manual for a Matsuura MC 510 VG?
Largest Manufacturing Technology Community on the Web
Stay Connected:
Anyone have the manual for a Matsuura MC 510 VG?
- Thread starter smartcolombyan
- Start date
- Replies 10
- Views 2,613
What is special about the G? I have the 510V manual. Unfortunately the manual quality doesn't approach the quality of the machine 
Have you tried Matsuura? If you are polite, they are usually quite helpful, though some old stuff has slipped through the archive cracks.
Have you tried Matsuura? If you are polite, they are usually quite helpful, though some old stuff has slipped through the archive cracks.
smartcolombyan
Plastic
- Joined
- Dec 24, 2020
What is special about the G? I have the 510V manual. Unfortunately the manual quality doesn't approach the quality of the machine
Have you tried Matsuura? If you are polite, they are usually quite helpful, though some old stuff has slipped through the archive cracks.
I've tried multiple times talking to a couple of representatives in the States, and even went so far as to trying UK Matsuura since the machine was initially distributed there, but no luck. Do you happen to have the manual in electronic form? It's nice to meet another CNC Machinist in PA as well
Strange. I've had positive experiences with Matsuura USA. I'm actually amazed at their willingness to support machines which are downright ancient, as long as you are polite and make reasonable demands.
I think they deserve public credit for being much better about this than most machinery companies.
(PMed you with info to get you the manual)
I think they deserve public credit for being much better about this than most machinery companies.
(PMed you with info to get you the manual)
smartcolombyan
Plastic
- Joined
- Dec 24, 2020
For anyone still looking for the manuals for the matsuura mc 510 vg. I finally tracked them down. Here is a link hosted from Yamazen: Dropbox - MC-510VG 10207 J300A UK Machine - Simplify your life
Hi! you solved the problem with settings?
I have MС-510VGm, if they suit you, then I'll take them off and send them to you.
My machine is MC-510V with yasnac mx3 control is not the same controller of MC-510VG
Yes, unfortunately not the one, I have a J300.