What's new
What's new

CHNC-1 Parts Catcher

TripleCautionMW

Plastic
Joined
Jun 21, 2018
Playing around today with the parts catcher on my Hardinge CHNC-1 and found an interesting problem. When I key in M26 in the over store screen it extends the parts catcher, key in M25 and it retracts without any issues. Then I add the M26 code into my program and it extends for about 5 seconds, retracts in for about 3 seconds, and then extends back out for a couple of seconds until the M25 is read.

Has anyone run into this issue before? Seems strange that it stays extended when in over store, but retracts in automatic mode.
 








 
Top