implmex
Diamond
- Joined
- Jun 23, 2002
- Location
- Vancouver BC Canada
Hi All:
A quick question for all you Mastercam drivers:
I'm having a helluva time trying to place a point where two lines would intersect if they were longer.
It was easy to do in the old Mastercam I'm used to, but I can't figure out how to do it in Mastercam 2022.
The help utility is useless, Google is useless too, so I'm stuck.
I resorted to just extending the lines until they intersected, putting my point there and then trimming the lines back again, but that's a really stupid way to have to do it.
Surely they did not kill that function and I just can't find it in the new GUI.
Would they really kill something so basic and useful?
Would they??
Cheers
Marcus
Implant Mechanix • Design & Innovation > HOME
Vancouver Wire EDM -- Wire EDM Machining
A quick question for all you Mastercam drivers:
I'm having a helluva time trying to place a point where two lines would intersect if they were longer.
It was easy to do in the old Mastercam I'm used to, but I can't figure out how to do it in Mastercam 2022.
The help utility is useless, Google is useless too, so I'm stuck.
I resorted to just extending the lines until they intersected, putting my point there and then trimming the lines back again, but that's a really stupid way to have to do it.
Surely they did not kill that function and I just can't find it in the new GUI.
Would they really kill something so basic and useful?
Would they??
Cheers
Marcus
Implant Mechanix • Design & Innovation > HOME
Vancouver Wire EDM -- Wire EDM Machining