Well I finally got my D10-30 running and cycling and I noticed that the table cylinder is leaking quite a bit around the shaft. Has anybody ever rebuilt one of these cylinders ?
I am assuming I will have to lift off the table and remove the cylinder to do this although I would like to just remove the end cap and put a new seal in the cylinder I don't think ill get off that easily. Does anyone know of a source for the rebuild kit and how to lift off the table ? Is it as simple as just lifting it up off the saddle with an engine hoist ?
I am assuming I will have to lift off the table and remove the cylinder to do this although I would like to just remove the end cap and put a new seal in the cylinder I don't think ill get off that easily. Does anyone know of a source for the rebuild kit and how to lift off the table ? Is it as simple as just lifting it up off the saddle with an engine hoist ?