EE Apron thrust Bearings.

[daryl bane]

Here is a rough sketch of some bearings/numbers that I sent to Bob at General Bearings probably 20yrs ago. I was going thru my files, and I didn't know if this would be handy or even relevant now. The first two 1) &2) might not be for the Monarch(maybe Tree mill) I just don't remember.

 

[daryl bane]

Ok, I figure this out. If you go to "Open link in new tab" you can down load it. ...I think. Cal, maybe you can clean this up and put it in a sticky?? If this info is not already available.

 

[Cal Haines]

It opens an a new window when I click on it (Windows desktop).