camaro_dan67
Cast Iron
- Joined
- Dec 4, 2009
- Location
- N.E. Pa.
I have an older Fanuc 3m control. I'm trying to figure out how to reset the parts counter. I'm guessing the control is counting M30's at the program end. I don't need to enter anything in the program for counting parts it just does it. It also shows run time. My guess is some kind of code gets entered into MDI and cycle start is probably pressed.
One other thing I'm looking for is if there is a way to reset the relative screen from inside the program. I want to make the z read 0 when each tool reaches Z0 on the part.
Thanks everyone.
One other thing I'm looking for is if there is a way to reset the relative screen from inside the program. I want to make the z read 0 when each tool reaches Z0 on the part.
Thanks everyone.
