What's new
What's new

FP2 square head removal

Kobusvn

Plastic
Joined
Dec 17, 2018
Hi all, I bought a Deckel FP2 Activ a while ago and I am busy sorting out all the niggles.

I need to check if the previous owners used the right grease etcetera in die spindle bearings and I want to give the vertical head a new coat of paint while I am at it.

The only problem is that I cannot seem to get the think off the drive gear. I have obviously removed the four bolts locking it into position. There is a hex thing that looks like a bolt on the left where the stop is at that just turns around and will not come out. I assumed this might have been some sort of lock pin.

Does anyone have any advice or able to tell me if I am missong something?

Thanks.

Kobus
 








 
Top