BluishInventor
Aluminum
- Joined
- Jul 7, 2020
Hi everyone,
We have a Trak Lathe 1630 SMX control CNC. It appears that we need to swap G2 and G3 for proper code output regarding arcs. It's almost as if it is utilizing a left handed coordinate system rather than right.
So, having X+ point towards the operator and Z+ points away from the chuck, Y should then point down. Correct?
In the case of this machine the Y points up, thus reversing the CW and CCW arc requirements.
Anyone else see this before? Our 2 other front turret 2x lathes (Fanuc and Centroid controls) do no require this.
We have a Trak Lathe 1630 SMX control CNC. It appears that we need to swap G2 and G3 for proper code output regarding arcs. It's almost as if it is utilizing a left handed coordinate system rather than right.
So, having X+ point towards the operator and Z+ points away from the chuck, Y should then point down. Correct?
In the case of this machine the Y points up, thus reversing the CW and CCW arc requirements.
Anyone else see this before? Our 2 other front turret 2x lathes (Fanuc and Centroid controls) do no require this.