FS Kuroda NMTB50 Auto Boring and Facing Head

[JBishop]

FS Kuroda boring and facing head, made in Japan, said to be a Wohlhaupter clone, takes 7/8" tooling. I found this in a damp basement at an estate sale, has some minor rust pitting, mostly on the mounting shank, don't think it will affect use. In a wood case with a bunch of accessories, but some are missing also. Case is a little worse for wear, has a punky spot on the bottom, some delamination inside. $375. plus shipping. Fairly heavy, shipping likely not cheap. Could probably ship everything but the case in a large flat rate box if desired.
Thank you, Jim Bishop [email protected] ph 774-696-059nine

 

[JBishop]

Couple pics didn't load

 

[Toolmaker51]

If your not in a hurry, I'd consider purchase of this. I'm planning a trip retrieving equipment from MI, central PA and HGR in Euclid; whats a few hundred extra miles? I have 3 50 taper spindles, so it would see decent use.........

 

[JBishop]

I can wait as far as storing it, no problem, doesn't take up much room. Just need to know about payment.

 

[hvnlymachining]

I'll take second dibs on that but will need it shipped.