FS: Matsuura Tool Setter

[Pete Deal]

I bought this Tool Setter from HGR hoping it was for 30 taper. It's for 40 taper. It looks rough but it will clean up nice. The tapers look good and it's mostly just grime on it. I have $150 in it total and would like that out of it. Can also have the CAT 40 drill chuck adapter shown with it.

I should add that it's missing the pull stud retainer that holds it in the horizontal spindle. I think it's just a little ball bearing cage thing. Shouldn't be very difficult to make.

It's very heavy, close to 100 lb so I'd rather not ship it. Pick up or I can meet someone somewhere.

 

[mutiny]

That thing looks awesome. I'm not too far but far enough that a drive probably doesn't make sense. Would make a fun minor restoration project though.

Good luck with the sale.

 

[Pete Deal]

Well I don't plan to be near the Aland Islands soon (wherever that is) but do have trips planned over the next month and a half to North western PA, northeastern ohio, South Carolina, and North Jersey.