What's new
What's new

FS: R8 tooling - collets, boring head, 14N drill chuck, endmill holders, mahoosive shell mill, slotting saw holders

mattthemuppet

Stainless
Joined
Apr 22, 2016
Location
San Antonio
IMG20231111201047.jpg

Collets, 3/8, 7/16, 1/2, 9/16, 5/8, 11/16, 3/4 and 7/8. Two each of the 3/8 and 3/4, which is good because one of each of them is on the rough side :) $20
IMG20231111201054.jpgIMG20231111201058.jpg
Bridgeport no.2 3" boring head for 5/8" tooling. Cleaned and regreased, tight and smooth. $80
IMG20231111201113.jpgIMG20231111201401.jpg
Ridonculous ETM 1.5" pilot shell/face mill arbor with 4" shell mill. That'll impress the ladies! $20
IMG20231111201127.jpg
Jacobs 14N super chuck, smooth throughout it's range (opening and closing), jaws look decent, arbor is a bit beat but functional. No key. $50
IMG20231111201135.jpgIMG20231111201150.jpgIMG20231111201205.jpg
 
Endmill holders 7/8" (no screws), three 1" and one 1.25". $10 each for the ones with a screw, $5 for the one without
IMG20231111201213.jpgIMG20231111201216.jpg
Slotting saw arbor, very good condition $30
IMG20231111201223.jpg
Slotting saw arbor in, ahem, functional condition and four double angle cutters (60 and 90deg), $30
IMG20231111201228.jpg
And that face mill peeking out of the last pic, free with any of the above (needs screw and carbide seat)
 
Forgot I had this, Sandvik 2 flute (!) 2" face mill with some spare used but usable inserts. I do not know why 2 flutes were ground off, but it looks well done and the cutter is in otherwise great condition. $50IMG20231111203144.jpgIMG20231111203154.jpgIMG20231111203158.jpg
 
View attachment 415711

Collets, 3/8, 7/16, 1/2, 9/16, 5/8, 11/16, 3/4 and 7/8. Two each of the 3/8 and 3/4, which is good because one of each of them is on the rough side :) $20
View attachment 415712View attachment 415713
Bridgeport no.2 3" boring head for 5/8" tooling. Cleaned and regreased, tight and smooth. $80
View attachment 415714View attachment 415715
Ridonculous ETM 1.5" pilot shell/face mill arbor with 4" shell mill. That'll impress the ladies! $20
View attachment 415716
Jacobs 14N super chuck, smooth throughout it's range (opening and closing), jaws look decent, arbor is a bit beat but functional. No key. $50
View attachment 415717View attachment 415718View attachment 415719
 
It has, I'm sorry. I do have this APT head with an integral 1" straight shank though :) Cleaned and regreased, moves very smoothly, missing a couple of set screws to hold bars (though I'm pretty sure I have some back in Texas) $70IMG20231122144353.jpgIMG20231122144403.jpgIMG20231122144413.jpgIMG20231122144424.jpg
 








 
Back
Top