Ron_P
Aluminum
- Joined
- Sep 30, 2009
- Location
- The Holler
(1) 1"
(1) 7/8"
(1) 3/4"
(1) 5/8"
(2) 1/2"
(2) 3/8"
(1) NTMB 40 collet adapter
Most are in very good shape. The 3/4", one of the 3/8", and maybe one of the 1/2" have light galling on the ID (If I were keeping them I would repair them with a suitably sized carbide drill or end mill shank and some lapping compound).
The NMTB 40 adapter is in good shape, there were a few dings on the taper but I stoned them out and I believe it's good to go. These came with a recently acquired Cincinnati Toolmaster.
Shipping will be actual cost from 45053.
(1) 7/8"
(1) 3/4"
(1) 5/8"
(2) 1/2"
(2) 3/8"
(1) NTMB 40 collet adapter
Most are in very good shape. The 3/4", one of the 3/8", and maybe one of the 1/2" have light galling on the ID (If I were keeping them I would repair them with a suitably sized carbide drill or end mill shank and some lapping compound).
The NMTB 40 adapter is in good shape, there were a few dings on the taper but I stoned them out and I believe it's good to go. These came with a recently acquired Cincinnati Toolmaster.
Shipping will be actual cost from 45053.
