Full tear down and Rebuild of a 10EE Round Dial

[GrantGunderson]

Turns out I had more hardware than I had realized.

My machine tool cutters are also in the right cabinet.


O rings on Left, Wire terminals on Right

Furniture / picture hanging stuff on left, wire terminals on right


Oetiker, Compression and flair fittings on left, grommets on right

Pipe fittings on left, paint supplies on right


retaining rings

machine keys and pins

At some point, I might change the drawer order, but thats okay as the entire system is completely modular.

 

[1yesca]

Turns out I had more hardware than I had realized.
View attachment 393049
My machine tool cutters are also in the right cabinet.
View attachment 393050
View attachment 393051
O rings on Left, Wire terminals on Right
View attachment 393052
Furniture / picture hanging stuff on left, wire terminals on right
View attachment 393053
View attachment 393054
Oetiker, Compression and flair fittings on left, grommets on right
View attachment 393055
Pipe fittings on left, paint supplies on right
View attachment 393056
View attachment 393057
retaining rings
View attachment 393060
machine keys and pins

At some point, I might change the drawer order, but thats okay as the entire system is completely modular.

now that's fascinating

 

[kd8303]

I used some non-marking pliers to rotate the index selector shaft, so that the witness marks align. I used a red sharpie to make them more visible. I dont know if these need to be in line for disassembly, but figuring the factory had its reasons for them, I am going to make sure they are aligned before I proceed. sad dp