G Code Sequential Engraving - Hurco

[newtoid1986]

Hi guys,
I’m struggling to write the code to sequential engrave on a Hurco. We don’t have NC Merge. It’s a job I have had to program on CAM and we cannot post process to sequential engrave from there.

So I would like to add a line to engrave at the end.

I was given this by Hurco:
G65 P9700 R2.0 Z-1.0 E500. F500. H6.0 Q10.

Unfortunately it says the Macro sub program does not exist. I understand that under height offset #098 I put the starting number.

Anyone engraved like this on a Hurco?

Thanks
James