Does anyone know how you can measure / quantify the amount of preload on a spindle bearing for a Colchester Master 2500?
Upon disassembly there are in place 12 coil springs, which apply the preload to the bearing.
I am assuming this is the correct number of springs? as there are holes drilled for 24 springs, a spring installed in every second hole
I have sent a request for advice to Colchester and Gamet, so far no response.
Dave
Upon disassembly there are in place 12 coil springs, which apply the preload to the bearing.
I am assuming this is the correct number of springs? as there are holes drilled for 24 springs, a spring installed in every second hole
I have sent a request for advice to Colchester and Gamet, so far no response.
Dave