What's new
What's new

Getting an error on my Okuma control.

graemeian

Plastic
Joined
Dec 24, 2010
Location
north carolina
My Hardinge GX1000 OSP gives an error mostly when the machine axes are not moving. I get the following: 1151-01 ALARM-A MCS Exception Processing X-AXIS 9D20910 '#2'.
When I go to the diagnostic page, I see the following: diagnostic code 15305 meaning the Z-axis servo is not okay. It is currently running now. While running, it gives me the error and stops about every few hours. When ON and not moving, I get the error about every 30 minutes. I looked at the Z-axis servo and wiggled the wires. It appears rock steady with no hunting. Do you have any suggestions?
 








 
Back
Top