Haas indexer help

[BROTHERFRANK]

Hi all. I have a client that is running a 1995 VF3 with a triple 5C indexer unit. He wants to retire the VF3 but continue to use the 5C unit on a new machine. The 5C is currently running direct from the Haas control. To run on a non-Haas machine, they will need to make it run from a Haas control box fired by an Mcode from the new machine with a finish signal going back. Can anyone shed some light on what will be needed on the Haas side? In other words what Haas control box will be needed to run the 5C unit? Thank you.

 

[Garwood]

SOFTWARE-36 BRUSH 17 PIN HAAS CONTROL BOX SCO1M ROTARY TABLE INDEXER LOT #22 LMS | eBay

I'm not a Haaspert, but I think you need a red one like this.

 

[BROTHERFRANK]

SOFTWARE-36 BRUSH 17 PIN HAAS CONTROL BOX SCO1M ROTARY TABLE INDEXER LOT #22 LMS | eBay

I'm not a Haaspert, but I think you need a red one like this.

Thanks Garwood. This ebayer was recommended to me by another contact too. I sent the ebayer a question to see if they can help us determine which box to use. I see there are different software versions available... It looks hopeful though. My client just had the rotary unit gone through and they are hoping to get some more use out of it. They are about $30k plus new.