Haas Mini Mill 311 Alarm "Unknown code"

[MrTurtle]

Does anyone know what could be causing this alarm? We just got this alarm and I have never seen anything like it. Comes up whenever we run any probing cycle. Ran off the VQC with the same result. It looks like it add a (?) in the macro line for some reason. The only thing iv'e found online is a cod ebook that tells me it could have been memory corruption due to a bad battery. Not sure which battery it referes to though.

The first thing we did was replaced the batteries in the probe, shut the machine down and restart, and look in the electrical cabinet to check for aything strange. Nothing.

 

[mhajicek]

Here's my O9832. Looks like you should replace the "? 7" with a "G04".

%
O09832 (OMP40 ON RENISHAW V3.24 FOR NGC)
G103 P1
#3001= 0
G04 P1
G04 P1
G04 P1
G04 P250
G04 P1
G04 P1
G04 P1
IF [ #3001 LT 200 ] GOTO999 (TEST RUNNING IN GRAPHICS)
G90 G80 G40 G94
IF[#598 NE 1.]G65 P9725 (MACHINE CHECK)
M19
N2
#4= 0
N3
(#6996 = 710) (NO HS3 WITH NGC)
(#5 = #30710) (STATUS OF PARAMETER 710)
(IF [ #5 NE 8 ] GOTO200)
(M69 P1136) (NEITHER PROBE ON M65 HS3 ONLY)
(GOTO201)
(N200)
IF[#12002 EQ 0]GOTO50
M69 P3 (NEITHER PROBE ON) (NGC)
(N201)
G04 P200
(***)
N50
(***)
#4= #4 + 1 (TRY TURN ON 4 TIMES)
IF [ #4 EQ 4 ] GOTO4
M69 P2 (NGC)
G04 P200
(#6996 = 710) (NO HS3 WITH NGC)
(#5 = #30710) (STATUS OF PARAMETER 710)
(IF [ #5 NE 8 ] GOTO100)
(M59 P1136) (PROBE ON M55 HS3 ONLY)
(GOTO101)
(N100)
M59 P3 (PROBE ON M53) (NGC)
(N101)
#3001= 0 (RESET MS TIMER)
WH [ #11017 NE 0 ] DO1 (WAIT FOR OMP40 ON) (NGC)
IF [ #3001 GT 3000. ] GOTO3 (OMP40 FAIL TO TURN ON AFTER 3 SEC TRY AGAIN)
END1
GOTO5
N4
#3000= 101 (PROBE START UP FAILURE)
N5
N999
G103
(G04 P1.)
M99



%

 

[MrTurtle]

What's strange is that we didn't change anything ourselves on the machine. It was running great probing cycles all day and then kicks up this alarm out of nowhere.

Could you help me with how I would go about changing the line that it appears on? I've never had to edit a macro line before.

 

[mhajicek]

Could you help me with how I would go about changing the line that it appears on? I've never had to edit a macro line before.

The same way you would edit any other program. Looks like setting 23 protects 9000 series programs, but should also prevent you from looking at it when protected.

23 - 9xxx Progs Edit Lock

www.haascnc.com