Hard to find used! Phase Perfect DPC-20

[Nerv]

Hi everyone,

I have a 20HP Phase perfect unit in great shape.

They are worth a lot of money new, $5k I think. I'll take $3k (USD) plus shipping (Or you arrange shipping), unit is located here in Calgary, Alberta. I have a forklift and can load into a truck if needed.

Regards,

Dave

 

[Nerv]

No one needs a 20 HP Phase perfect? They sure were hard to come by when I have needed them over the years!

 

[dustpan3]

No one needs a 20 HP Phase perfect? They sure were hard to come by when I have needed them over the years!

Do you have any specs on the unit or pictures available?


Sent from my iPhone using Tapatalk

 

[Monarchist]

Do you have any specs on the unit or pictures available?

Manuals are still online. "Looks?". It's a box. Rectangular, even.

I suspect the barrier is that Calgary, Alberta, Canada is a long way and 230 lbs avoir + pallet distant from those actively seeking this particular (holiday) week.

OTOH, they are not hard to palletize. My 10 HP managed SD to VA w/o harm. Four bolts, two edge-protectors, two straps across same.

Bill

 

[Nerv]

...I suspect the barrier is that Calgary, Alberta, Canada is a long way and 230 lbs avoir + pallet distant from those actively seeking this particular (holiday) week...

I suppose this might be true, but I'm not sure why that is a big deal. I had it shipped 2200 miles to me, strapped to a pallet. It wasn't all that expensive and the unit looks and works great. The Phase Perfect I had before it (a 10HP) came from the southern states to here and was worth the hassle and money.

If anyone is thinking of running a CNC at the house or increasing power to run a couple machines then this is a "perfect" solution. Please contact me if you are interested!

Dave @ Nerv

 

[Nerv]

Phase Perfect, 20HP, still have it. Didn't know this forum wouldn't let me know if someone had messaged me about it,

If interested please contact me: [email protected]

Thanks!

 

[JLarsson]

Phase Perfect, 20HP, still have it. Didn't know this forum wouldn't let me know if someone had messaged me about it,

If interested please contact me: [email protected]

Thanks!

Ah, but it WILL, but only if you configure your account to do so.

At the top of any PM page, click on "Settings". Then scroll down until you find "My Settings" at the left. Under that, click on "General Settings". Check the circle next to "Receive Email Notification of New Private Messages". Then scroll all the way to the bottom and click on "Save Changes".

 

[Monarchist]

I suppose this might be true, but I'm not sure why that is a big deal. I had it shipped 2200 miles to me, strapped to a pallet. It wasn't all that expensive and the unit looks and works great. The Phase Perfect I had before it (a 10HP) came from the southern states to here and was worth the hassle and money.

Agree it need NOT be a 'big deal'. My recently acquired 10 HP P-P came half way across the USA as well. Properly palletized, undamaged, and affordably shipped.

Trusting that you have just clarified that you can and will prep this one to travel as neatly.

Hope that helps find a new home for it.

Bill