Wiktor
Plastic
- Joined
- Sep 26, 2022
First of all - greetings from Poland!
I just recently bought a surface grinder made in U.S.A - Harig 612. Unfortunately, due to my lack of experience and knowledge, I did not properly secure the table for transportation and the table slipped of the machine. Luckily, I did not loose it. But a few rollers from linear roller bearing are damaged (below there is picture of similar setup). After swift period of grief, I'm looking into my options what to do with it. I tried to find replacement bearing or just the rollers but no luck here. I also find some posts here on the forum stating that people have these machines without rollers at all (also the manual does not seem to mention that part). I would very appreciate any advice how to tuckle this problem.
I just recently bought a surface grinder made in U.S.A - Harig 612. Unfortunately, due to my lack of experience and knowledge, I did not properly secure the table for transportation and the table slipped of the machine. Luckily, I did not loose it. But a few rollers from linear roller bearing are damaged (below there is picture of similar setup). After swift period of grief, I'm looking into my options what to do with it. I tried to find replacement bearing or just the rollers but no luck here. I also find some posts here on the forum stating that people have these machines without rollers at all (also the manual does not seem to mention that part). I would very appreciate any advice how to tuckle this problem.