US-Choppers
Plastic
- Joined
- Mar 17, 2020
Hi all, $4000 obo
I am selling my very clean low use 11" Harrison M250. I have owned it the last 20 yrs or so and was using it in my garage (220V) before I re-opened my shop 10 years back. It sounds like and runs like a finely tuned sewing machine- very quiet and accurate - very little wear overall and zero issues. It has a nice complete taper , coolant, both steady and follow rests etc. I have the extra change gears as well for threading.
This is a very nice home lathe. I had my painter freshen it up w an industrial enamel paint -to the tune of $1000...(Lusid Northstar) which is almost bullet proof- it also has some clear protective sheet applied in heavy wear areas.
In So Cal.
Any q's feel free.
Best regards, Rick
Nine four Nine - 39four-8609 cell
I am selling my very clean low use 11" Harrison M250. I have owned it the last 20 yrs or so and was using it in my garage (220V) before I re-opened my shop 10 years back. It sounds like and runs like a finely tuned sewing machine- very quiet and accurate - very little wear overall and zero issues. It has a nice complete taper , coolant, both steady and follow rests etc. I have the extra change gears as well for threading.
This is a very nice home lathe. I had my painter freshen it up w an industrial enamel paint -to the tune of $1000...(Lusid Northstar) which is almost bullet proof- it also has some clear protective sheet applied in heavy wear areas.
In So Cal.
Any q's feel free.
Best regards, Rick
Nine four Nine - 39four-8609 cell