Help-replacement bevel gear for powerfeed

[jackalope]

I have a Vevor brand powerfeed that I need another bevel gear for. I’ve reached out to Vevor directly and they are useless. Does anyone k ow if the Lee is a source for replacement parts or one that will work. I saw one on eBay for Servo but not sure if it is interchangeable. Thanks in advance.

 

[bob]

I have a Vevor brand powerfeed that I need another bevel gear for. I’ve reached out to Vevor directly and they are useless. Does anyone k ow if the Lee is a source for replacement parts or one that will work. I saw one on eBay for Servo but not sure if it is interchangeable. Thanks in advance.

I have one generic China will post pic and details tomorrow

 

[Bill D]

Big or little one? I see lots of the big gears on the bay.
Bill D

 

[jackalope]

Big or little one? I see lots of the big gears on the bay.
Bill D

Al-310s with the 450 inch/lb torque. I’m adapting it to my Series II and want a back up in the event I screw it up or it fails. Thanks

 

[Gordon Heaton]

I think Bill is asking is it the big bevel gear or the small one.

 

[Bill D]

I think Bill is asking is it the big bevel gear or the small one.

correct. The big gear on the mill. or the little one on the feeder.

 

[bob]

I have the two shown in pictures both new. If they will work for you let me know best to use [email protected]
Bob

 

[jackalope]

I have the two shown in pictures both new. If they will work for you let me know best to use [email protected]
Bob

Bob, I bit the bullet and machined the end of my leadscrew after extending it 4 mor inches. I have a series II and wanted to add a powerfeed. Was going to machine there bevel gear but was impatient. If this doesn’t shake down I may hit ya up. So far it is working great.