So I have roughly 5000 holes to tap on small parts made out of 6061-T6. My callout is a 0-80 UNF tap .224 down in a blind hole thats .287 deep. What I have gathered so far is the following:
-Use a # 54 Carbide Circuit Board drill (not sure why) @ 6000 RMM & 10 IPM
-Use a roll form tap @ 1200 RPM with normal coolant
Is this info good? also, can I expect 1 tap to get thru all 5000 pcs? Thanks for the help guys!
-Use a # 54 Carbide Circuit Board drill (not sure why) @ 6000 RMM & 10 IPM
-Use a roll form tap @ 1200 RPM with normal coolant
Is this info good? also, can I expect 1 tap to get thru all 5000 pcs? Thanks for the help guys!