spope14
Stainless
- Joined
- Jan 29, 2004
- Location
- Claremont, NH
I have a Fanuc 11TE controlled Slant 2 NakaTome Methods lathe. The X axis runs X- programming for diameters, as mentioned in a previous post string. I was given the information to change parameter 1879 from -111 to 111. Problem is, I can not find a parameter 1879.
I have gone through all the parameters I can find in the control, but have to wonder, are there some hidden parameters only available through very hard to find methodology?
Help would be appreciated.
I am also having RS232 communications problems, but thought I saw a thread about this.
I have gone through all the parameters I can find in the control, but have to wonder, are there some hidden parameters only available through very hard to find methodology?
Help would be appreciated.
I am also having RS232 communications problems, but thought I saw a thread about this.