Need some trouble shooting help. I installed a 3ph 3hp motor powered by a Hitachi WJ200 drive. Motor runs fine, starts/stops on the keypad controls.
I want to run push button controls and so I thought I setup the inverter to accept push button controls. In doing so I swapped the logic jumper from P24 to L, ran P24 through push buttons and set them to 1 and 2. I set C001 to 20 and C002 to 21, I also set A002 to 01. All according to spec and same as I have on another machine. Only, nothing happens.
I checked the P24 lead and it shows less than 1 volt, the same setup on the other inverter shows higher voltage at the P24 terminal Not sure what I’ve done wrong here but appreciate any troubleshooting input. Thank you!
I want to run push button controls and so I thought I setup the inverter to accept push button controls. In doing so I swapped the logic jumper from P24 to L, ran P24 through push buttons and set them to 1 and 2. I set C001 to 20 and C002 to 21, I also set A002 to 01. All according to spec and same as I have on another machine. Only, nothing happens.
I checked the P24 lead and it shows less than 1 volt, the same setup on the other inverter shows higher voltage at the P24 terminal Not sure what I’ve done wrong here but appreciate any troubleshooting input. Thank you!