What's new
What's new

hobart handler with 90/10 gas

buttfarts

Plastic
Joined
Dec 10, 2012
Location
Dallas
Hobart handler 140.

All the shop has available that I'm in is the 10% co2 and 90%argon.

I've dabbled a little with this set up, I'd prefer 25/75 but gotta use what's available.

Any tips or advice with using this combination?
 
From what I know, higher argon concentrations will have less spatter on short circuit (mig), but also less heat input into the part, so less penetration.
 
C10 will allow a machine to kick into spray mode. Which would fry a HH140 quickly. So stick to short circuit and you will be fine.
 








 
Back
Top