How to calibrate Doosan Lynx 220 Q-Setter arm?

[6010fd12]

I work on a Doosan Lynx 220 at my job and while getting up a grover on the probe I didn't notice that the turret was contacting the probe arm first before the tool and while I was jogging to zero the Z axis it was actually pushing the arm forward until the machine eventually threw an error.

Now when I go to zero the top X Axis it is off by around .006". Is there any way to adjust the offset up for the probe?
I have seen another thread where someone mentioned that parameters 5015 - 5018 control the probe offset but my machine does that have these parameters(only has 5015)

 

[MaxPrairie]

That is 5115 in the picture. Page up in your parameters.

 

[6010fd12]

You're right. I'm blind. I was looking ending digits and didn't even notice the second one. I paged up and found all the parameters. Thank you