Integrated Cat40 insert drill

[zachrabbit15]

Hello, does anyone still make a Integrated Cat40 insert drill? Years ago I hade a Wohlhaupter 1.5" 4x drill that was CAT40. Would be so useful now instead of having to use a giant 1.25" set-screw holder to hold one of the lathe departments drills and keep from having a 20" long tool sticking out of the machine. Hopefully this image ink works showing one of the tools.
Thanks for any help
Zach

https://www.mtwmag.com/wp-content/uploads/2018/06/Allied-Wohlhaupter-Products.jpg

 

[gregormarwick]

Hello, does anyone still make a Integrated Cat40 insert drill? Years ago I hade a Wohlhaupter 1.5" 4x drill that was CAT40. Would be so useful now instead of having to use a giant 1.25" set-screw holder to hold one of the lathe departments drills and keep from having a 20" long tool sticking out of the machine. Hopefully this image ink works showing one of the tools.
Thanks for any help
Zach

https://www.mtwmag.com/wp-content/uploads/2018/06/Allied-Wohlhaupter-Products.jpg

Probably there are a few floating about, but an integrated capto drill on a stubby capto-40 taper back end will be about the same gauge length as an integrated one.

 

[Mtndew]

Hello, does anyone still make a Integrated Cat40 insert drill? Years ago I hade a Wohlhaupter 1.5" 4x drill that was CAT40. Would be so useful now instead of having to use a giant 1.25" set-screw holder to hold one of the lathe departments drills and keep from having a 20" long tool sticking out of the machine. Hopefully this image ink works showing one of the tools.
Thanks for any help
Zach

https://www.mtwmag.com/wp-content/uploads/2018/06/Allied-Wohlhaupter-Products.jpg

The picture you attached is from Allied's website.... have you even tried looking at their page?

 

[ChipSplitter]

Take a look at Allied W3803H-CV40. It's "3xD", but actually reaches 5.125.