Ultradog MN
Cast Iron
- Joined
- Jun 14, 2020
I answered an ad on CL for some tooling.
Went over there and met an older gent who had a lot of stuff left over from a tool and die shop he co-owned but had retired and closed the place.
When I walked into his home shop I instantly recognized his Monarch C.
Nice old machine. It was the one he kept of the several they had in their shop.
Some interesting features on it though.
First was this auxilliary shaft sticking out from the head stock. I think I've seen this device in a piece of literature somewhere.
Was this for a power compound rest?
The back end if it has the chart for the various speeds or feeds.
The other interesting thing on the lathe was the gear handles.
Notice they are not hinged. Just detents to lock them in place.
I suppose it has to do with that aux drive since if there was a drive shaft going across the front of the head stock you couldn't pull the handles out to change gears.
I snapped a couple of photos for you guys.
I didn't buy anything from him.
Too expensive for my thin wallet.
But I did spend a rather pleasant hour chatting with him so it was worth the trip to see him - and his lathe.
Went over there and met an older gent who had a lot of stuff left over from a tool and die shop he co-owned but had retired and closed the place.
When I walked into his home shop I instantly recognized his Monarch C.
Nice old machine. It was the one he kept of the several they had in their shop.
Some interesting features on it though.
First was this auxilliary shaft sticking out from the head stock. I think I've seen this device in a piece of literature somewhere.
Was this for a power compound rest?
The back end if it has the chart for the various speeds or feeds.
The other interesting thing on the lathe was the gear handles.
Notice they are not hinged. Just detents to lock them in place.
I suppose it has to do with that aux drive since if there was a drive shaft going across the front of the head stock you couldn't pull the handles out to change gears.
I snapped a couple of photos for you guys.
I didn't buy anything from him.
Too expensive for my thin wallet.
But I did spend a rather pleasant hour chatting with him so it was worth the trip to see him - and his lathe.