What's new
What's new

Issue With my Lathe Receiving Programs

Hi everyone. I have a Methods Slant 50 Lathe with a Yasnac J50L Control.

I've purchased it recently, and sent about 5 programs into it via CIMCO
Today I tried to send another program but nothing happens, I don't get any errors or anything, and the software is stuck at Status: Sending with nothing going further.

I thought that the cable was bad, but tried two of my other machines and had no issues sending or receiving programs.

This issue started that I couldn't send a program from the machine to the PC, but vise-versa worked, now nothing works. Does anyone have any solutions for this issue, or any troubleshooting advise? Thanks.