What's new
What's new

Jacobs Rubberflex chuck Model 91-T00 and collets - L-00 mount

aribert

Cast Iron
Joined
Jul 2, 2008
Location
Metro Detroit, MI
I sold my Clausing 5914 lathe, with L-00 mount, a couple of years ago. I kept the Jacobs Rubberflex chuck and collets in the hope/expectation that I would eventually find a similar chuck with a D1-6 mount. A few weeks ago Lazz offered up such a chuck, I bought it and yesterday put it to use. So now I am offering up my L-00 mount Jacobs Rubberflex chuck with a full set of collets. The L-00 mount is integral to the chuck. $375 shipping (via USPS flat rate boxes) in the US included. Shipping outside of the US to be quoted.

A copy of the manual for this chuck can be seen here (NOTE: a Euro tooling dealer has superimposed their cover page and logo): https://amtc.eu/files/downloads/used-machinery-europe.nl/DAT/OCC-12-062.pdf
 

Attachments

  • SAM_6744.JPG
    SAM_6744.JPG
    326 KB · Views: 6
  • SAM_6751.JPG
    SAM_6751.JPG
    415.7 KB · Views: 6
  • SAM_6752.JPG
    SAM_6752.JPG
    415.8 KB · Views: 7
  • SAM_6756.JPG
    SAM_6756.JPG
    418.6 KB · Views: 7
  • SAM_6759.JPG
    SAM_6759.JPG
    415.9 KB · Views: 8
  • SAM_6761.JPG
    SAM_6761.JPG
    416 KB · Views: 6
  • SAM_6762.JPG
    SAM_6762.JPG
    412.6 KB · Views: 8
  • SAM_6765.JPG
    SAM_6765.JPG
    417.5 KB · Views: 7
  • SAM_6766.JPG
    SAM_6766.JPG
    420.5 KB · Views: 7
  • SAM_6769.JPG
    SAM_6769.JPG
    418.5 KB · Views: 6
Last edited:

aribert

Cast Iron
Joined
Jul 2, 2008
Location
Metro Detroit, MI
Marty
Agree the chuck mount in the manual is different - I was more focused on how the Rubberflex collet is installed and tightened - the face of the chuck is the same. I figured someone out there w/ an L00 mount lathe might be curious as to how these chucks are operated and hopefully they now realize they NEED this.
Years ago, shortly after Al Gore finished inventing the internet, I found a PDF copy of the manual online but yesterday I was unable to find any manual other than the one linked.
Aribert
 

aribert

Cast Iron
Joined
Jul 2, 2008
Location
Metro Detroit, MI
Yup, I have some outstanding, form fitting, packing (at least for the chuck face up thru the handwheel) readily available - just need an interested buyer.

BTW the chuck I bought from you works great, I'd forgotten how sweet it is to have collets with an 1/8 inch grip range when doing one off repair work. I'm keeping my own collet cap/nut, modified with a lead in on the keyway, and selling my chuck with the unmodified collet cap/nut from your chuck.
 








 
Top