Hello all,
I am trying to set up communication between OKUMA LB15 OSP5000 (Green Screen) and a PC, and I will appreciate your help.
The machine was connected to an ancient PC with old DNC software running on DOS, and it worked fine until the PC had perished.
Few days ago I installed DNC4U software on a new computer and connected it to the OKUMA LB15 via RS232.
All my attempts to send a program from the machine to the pc failed and the message "puncher error ffffffff" appeared. Sending from the PC to the machine failed too, and the message "PTR read error ffffffff" was displayed. Changing parameters of the DNC (parity, stop bits etc.) didn’t make a difference. I didn't change any parameters at the machine (don’t know which and how).
Does anyone have any suggestions or tips as to how to solve this?
Any guidance will be greatly appreciated.
Thanks in advance,
Z. Joseph
I am trying to set up communication between OKUMA LB15 OSP5000 (Green Screen) and a PC, and I will appreciate your help.
The machine was connected to an ancient PC with old DNC software running on DOS, and it worked fine until the PC had perished.
Few days ago I installed DNC4U software on a new computer and connected it to the OKUMA LB15 via RS232.
All my attempts to send a program from the machine to the pc failed and the message "puncher error ffffffff" appeared. Sending from the PC to the machine failed too, and the message "PTR read error ffffffff" was displayed. Changing parameters of the DNC (parity, stop bits etc.) didn’t make a difference. I didn't change any parameters at the machine (don’t know which and how).
Does anyone have any suggestions or tips as to how to solve this?
Any guidance will be greatly appreciated.
Thanks in advance,
Z. Joseph