Maho mh800 will not run - pressing green button does not execute reference point

[scott.bryce]

Problem Found.

240V Relay # 4K1 was burnt out (Coil was open circuit) and the Green Go Button command was prevented from being seen by the machine.

I will replace the coil and reply, hopefully with good news...

Thanks to everyone that assisted - much appreciated

 

[Milacron]

Problem Found.

240V Relay # 4K1 was burnt out (Coil was open circuit) and the Green Go Button command was prevented from being seen by the machine.

I will replace the coil and reply, hopefully with good news...

Thanks to everyone that assisted - much appreciated

Ah, the old defective coil trick... I haven't had that happen in so long on a CNC machine I forgot it was a possibility to investigate.... but I should have thought of that, as it happened to me once as well...not on a Maho, but the same situation.

 

[dmelacom]

Is the machine up and running?