DON CHANDLER
Plastic
- Joined
- Jan 5, 2022
Good morning. New member here. I have seen many posts on this issue, but not exactly......
My machine recently had the CRT replaced by DMG/Mori. The original CRT had a RS232 port where we loaded a memory card to run sub programs from. worked fine. replacement CRT only has 2 USB ports.
Is it possible to run a sub program from the USB port via flash drive???
I have changed the I/O settings as suggested in other posts, the errors I get are either:
FILE OPEN ERROR 2 (MC3110)
OR
ILLEGAL FILE NAME (MEMORY CARD) (SR1968)
Any help greatly appreciated !
My machine recently had the CRT replaced by DMG/Mori. The original CRT had a RS232 port where we loaded a memory card to run sub programs from. worked fine. replacement CRT only has 2 USB ports.
Is it possible to run a sub program from the USB port via flash drive???
I have changed the I/O settings as suggested in other posts, the errors I get are either:
FILE OPEN ERROR 2 (MC3110)
OR
ILLEGAL FILE NAME (MEMORY CARD) (SR1968)
Any help greatly appreciated !