What's new
What's new

Mori Seiki SL1 Chip Conveyor - $50.00?

Mori SL1 chip conveyor

I don't have the shop space for it. The shop that I got the lathe from did not either. I have not plugged it in, but expect that it works OK.

I would like to get $50 for it but open to offers. I am not going to use it and can use every inch of space that I can come up with.

Near Gettysburg, PA (17320)

Cannot deliver or ship, but can help load.

Thanks,

Bill

IMG_8619.jpg
 
That's a deal.

I would punch a hole through the wall or something to keep that on the machine.

If no one can use it, it will stay where it is in the corner. The lathe does not make enough chips to need the conveyor.

If there is a consensus that it is better to keep it with the lathe, I'll take down the listing.

Thanks,

Bill
 

Big B

Active member
If no one can use it, it will stay where it is in the corner. The lathe does not make enough chips to need the conveyor.

If there is a consensus that it is better to keep it with the lathe, I'll take down the listing.

Thanks,

Bill

Some day you may run something where it would come in handy and to find a different one will probably cost you a lot more than fifty bucks. I'd keep it.
 

DDoug

Active member
Should work good on corn & beans during harvest season, fit right under the lowest gravity wagon's chute or dump truck.....:D
 








 
Top