JohnnyJohnsoninWI
Hot Rolled
- Joined
- Dec 9, 2003
- Location
- North Freedom, WI, USA
This MoriSeiki MS1250 lathe was purchased from Greer Machinery about 5 years ago. They went through the apron and headstock to make sure everything was up to snuff. Greer also installed the DRO for me. It is the nicest lathe I've ever run.
Cuts inch or metric threads, plus it has a micrometer carriage stop and automatic carriage stop.
18" swing, 47" between centers. 5hp, 3-phase motor is wired 220V.
The Newall DRO and Pratt-Burnard 3-jaw 10" chuck both are four years old and like new.
Also comes with a 12" 4-jaw chuck, steady rest, follow rest, coolant pump, manuals, and Aloris BXA tool post with 4 tool holders. All are in excellent to like-new condition.
Asking $19,500.
John Hallis
North Freedom, WI
email: [email protected]
www.northfreedomengineering.com
YouTube channel: dauntlessendeavors1000
Cuts inch or metric threads, plus it has a micrometer carriage stop and automatic carriage stop.
18" swing, 47" between centers. 5hp, 3-phase motor is wired 220V.
The Newall DRO and Pratt-Burnard 3-jaw 10" chuck both are four years old and like new.
Also comes with a 12" 4-jaw chuck, steady rest, follow rest, coolant pump, manuals, and Aloris BXA tool post with 4 tool holders. All are in excellent to like-new condition.
Asking $19,500.
John Hallis
North Freedom, WI
email: [email protected]
www.northfreedomengineering.com
YouTube channel: dauntlessendeavors1000
Attachments
Last edited:
