[email protected]
Plastic
- Joined
- Dec 10, 2014
So I have a Mplus control that I have been using the Tool Data for both my diameters and length offsets reliably in EIA/ISO mode. However, because of the limitations of Tool Data, I'm unable to use cutter comp in a small diameter or confining hole like you could with a fanuc. In other words, setting your tool offset to zero and running your cam program, (Fusion 360) to "wear".
My question is, what can I do to either the parameters or the operation of the controller that would allow me to touch off my tools with the presetter and use EIA/ISO Diameter offsets?
Thank you for any help you can provide. I have a call into Mazak, but it's been days and I've heard nothing back.
My question is, what can I do to either the parameters or the operation of the controller that would allow me to touch off my tools with the presetter and use EIA/ISO Diameter offsets?
Thank you for any help you can provide. I have a call into Mazak, but it's been days and I've heard nothing back.
