Deerhurst
Plastic
- Joined
- Jun 6, 2022
I just got my BP tracer mill wired up (yay!! Took long enough!) And while doing a function check noticed I'm not getting any movement at the table.
The machine is a Syncho-Trace 2 with manual controls. I tried exercising the Z axis with "Trace" and "Retract" with no movement. Tried doing feed in all 4 directions in X and Y axis, nada. I can hear what sounds like solenoids clunking when I trigger "Run".
Yes, pump is running. The Lovejoy coupling is in tact.
I know this machine works. I ran it before I moved it to my house.
Suggestions?
The machine is a Syncho-Trace 2 with manual controls. I tried exercising the Z axis with "Trace" and "Retract" with no movement. Tried doing feed in all 4 directions in X and Y axis, nada. I can hear what sounds like solenoids clunking when I trigger "Run".
Yes, pump is running. The Lovejoy coupling is in tact.
I know this machine works. I ran it before I moved it to my house.
Suggestions?
