Okuma LB15 OSP5020L and LNS DH65 feeder

[Prebus]

Hello.
I am new to this forum and i have searched a lot after correct wiring diagram to a LNS Fedek DH 65. Sorry if i miss anything or rules.

We have buy a DH65 feeder to our Okuma LB15 Lathe, but someone have removed the 24 pin connection plug on the Lathe. I attached two pictures of the wiring clamp inside Lathe where the cable from the plug should be connected. Is there anyone who have a similar machine who can give me a diagram or anything who can tells me how to connect the 24 pin connector to this lathe?

Pardon my english. I am from Norway

 

[DouglasJRizzo]

Have you asked Okuma?
They support all the machines and controls going WAY back.

 

[Prebus]

Hello
Yes, but just the dealer in Norway. They send me what they have, but they havent any drawings about the external connector. Is it a worldwide standard with 24 pin Harting connector to external feeders?