Plasma cutting settings

[EmmanuelC]

Hello,
I am currrently testing a "homemade" CNC plasma cutter and I would like to find the proper feeds and settings depending on the material and it's thickness. I am however a bit lost. The plasma cutter is a GYS 45CT and I was unable to find any documents from the constructor on how to get the best cutting quality. I was wondering if anyone has found documents that could be used on this plasma post ?
Thanks !

 

[memphisjed]

https://www.hypertherm.com/en-US/hypertherm/powermax/powermax30-xp/ manual (pdf book) will get you close.

 

[DDoug]

Hello,
I am currrently testing a "homemade" CNC plasma cutter and I would like to find the proper feeds and settings depending on the material and it's thickness. I am however a bit lost. The plasma cutter is a GYS 45CT and I was unable to find any documents from the constructor on how to get the best cutting quality. I was wondering if anyone has found documents that could be used on this plasma post ?
Thanks !

Try over at "the Zone" ....cnc-zone.com

 

[crickets]

https://www.hypertherm.com/en-US/hypertherm/powermax/powermax30-xp/ manual (pdf book) will get you close.

Indeed! Hypertherm docs have good tables. It would also be worth to check Powermax 45 PDF since it seems like OP's unit can go up to 45A. But on end of the day one will have to learn to "read the cut" to determine what works, and what doesn't.