Robodrill new user

[Merdailleurs]

Hi all,

I am new to Robodrill and have some questions to ask to a seasoned machinist on a similar setup.

The machine is a a-T14if 24000RPM, Renishaw tool length touchless probe, Fanuc control is a 3ti-Model A5.

Machine was new in 2008.

My questions are related to the basics of running the machine.

First of all, I was expecting to have to initiates the axis on startup, it is not the case with this machine.

Can someone tell me what is the proper way to setup tool change height on this machine.(is it a requisite?)

The machine has just been plugged in, I will have air installed this afternoon, I have ordered the manuals from Elliott-Matsuura.
In the mean time your input is going to be invaluable to help me get beyond the first steps in understanding this control.

Thank you so much for your help!

Francois

 

[footpetaljones]

The axes use absolute encoders, so referencing isn't needed. The tool change height is set off of the Z axis home position. Don't fuck with it.

G65 P9862 is Renishaw's usual macro for tool setting with an NC4, but confirm that is the case on your machine. If you do have an NC4, download the manual here: Sign in to MyRenishaw.

 

[Merdailleurs]

Great, this is what I needed!

Thank you sir! Your help is much appreciated.