Setting zero position on Mitsubishi Meldas 64

[Eugen]

Can anyone help me with the zero point setting procedure for the Mitsubishi Meldas 64?
I have to change the encoder on the x-axis and I have to set zero point again.
Machine is a Vertical Machining Center.

Thanks in advance!

 

[DouglasJRizzo]

I believe Mitsubishi has documentation online in PDF format for free.

 

[Vancbiker]

Can anyone help me with the zero point setting procedure for the Mitsubishi Meldas 64?
I have to change the encoder on the x-axis and I have to set zero point again.
Machine is a Vertical Machining Center.

Thanks in advance!

Do you have absolute or incremental encoders?

If absolute, then your machine builder should have a table position in X to set the table at before the parameter procedure to set the absolute position. Do you know that position?

 

[Eugen]

I think it's an absolute encoder" Rotary encoder OSE104Se" is the encoder
I have the parameters from the machine manufacturer.
But I don't know what the position is, can I find it in the parameters? I haven't replaced the old encoder yet.

.

 

[Vancbiker]

OSE encoders are incremental. No absolute setting is required. After installing, do the normal homing process. Adjust the grid shift parameter if needed to fine tune the home position.

 

[Eugen]

Thank you very much for your help! I'll change the encoder. I was afraid that I would know how to do the zero home position procedure.