I'm sure the information I need is on this site but I cannot find it.
I'm trying to get my ducks in a row to finish a project tomorrow.
For the first time I am trying to turn an external metric thread.
I have swapped the gears as the gear chart suggest.
For 1mm thread pitch the thread gear chart says;
Plunger Hole - C
Then it says ;
Plunger Hole - 1
Could someone tell me if Plunger Hole 1 is the the same as "A-4" in Feeds?
Sorry, best pic I could post.
In other words, in feeds, are they referring to the top left hole?
Thank you very much ahead of time if some one has the time.