What's new
What's new

TSUGAMI BO38T M765 SWISS/COMPOSITION CONTROL MODE HELP

SWISSTAH

Plastic
Joined
Feb 1, 2024
Hi All-

I have a Tsugami BO38T 9-axis lathe that has a turret. I am trying to conduct Swiss machining using the turret (the turret is fixed while z1 moves) I am experiencing some oddities in tool location relative to z1. I ran top cut and touched off the turret tool but every time I run the m765 mode Z1 will be off by .130ish. If someone is out there with the same machine and knows how to set up the turret correctly so that it can be used in Swiss mode I would greatly appreciate any wisdom!!
Thank you!
 








 
Back
Top